在安裝可拆卸式保溫套時，

1.要檢察閥門和管道保溫是否符合安裝條件，

2.檢察保溫套外表是否完好。

3.需要測量接口尺寸并在保溫套外殼上畫出輪廓線。

4.沿輪廓線切割，完成后打開保溫套修整缺陷。

5.將保溫套扣在被保溫閥門上，擰緊螺栓，完成安裝

When installing a detachable insulating sleeve,

1., to check whether the valve and pipe insulation meets the installation conditions.

2. the inspection of the heat insulation cover is perfect.

3. it is necessary to measure the size of the interface and draw contours on the housing.

4. cut along the contour line, and then open the insulation sleeve to repair defects.

5. button the thermal insulation sleeve on the insulated valve, tighten the bolt and complete the installation.

安裝可拆卸式保溫套的注意事項：

1.由于施工現場情況復雜，未使用產品前不要將產品的包裝打開，以免造成污染或者碰撞。

2.安裝產品時，要將產品置于干凈平整的工作墊上，應避免拖拽，防止產品表面產生劃痕。

3.產品安裝完成后，在正式投產前，應使用防塵布等加以覆蓋，以免其它工種作業時造成污染或損壞。

4.再次拆裝時，要有順序的將拆下的保溫套放在事先鋪好的清潔墊上，注意保護產品編號清晰，以免安裝時找不到對應位置。

The precautions for installing the detachable insulating sleeve are:

1. due to the complexity of the construction site, do not open the product package before the product is used, so as not to cause pollution or collision.

2. when installing products, place products on clean and smooth work mats, avoid dragging and prevent scratches on the surfaces.

3. After the product is installed, it should be covered with dust-proof cloth before putting into production, so as to avoid pollution or damage caused by other types of work.

4. again when disassembly, there should be a sequence of dismantled thermal insulation on the pre laid clean pad, pay attention to the protection of the product number clear, so as not to find the corresponding position when the installation.